ELTEX SMG-4 - Page 190

190 SMG digital gateway
To configure LOS and AIS fault indication for an E1 stream, check the Alarm Indication checkbox.
To configure RAI fault indication, check the Remote Alarm Indication checkbox.
To configure slips indication for a stream, check the SLIP Indication checkbox and configure the SLIP
detection timer.
2) Configuration of optional failure indication for an SS-7 line group (the E1 Streams/SS-7 Line Group menu, see
section 4.1.5.4 SS-7 Signalling Protocol Configuration).
To configure SS-7 signal link fault indication, check the Fault Indication checkbox.
3) To enable SNMP, use the TCP/IP Settings/Network Interfaces menu (section 4.1.8.11 Network interfaces).