EMC DS-4900B - Verify Correct Operation and Backup the Configuration

Initial setup of the DS-4900B
2-15
Installing and Configuring the DS-4900B
Verify correct operation and backup the configuration
To verify correct operation and backup the switch configuration:
1. Check the LEDs to verify that all components are functional. For
information about LED patterns, see “Interpreting LED activity”
on page 3-2.
2. Use the switchShow command to verify that the ports are enabled
and alive. Without the Ports on Demand licenses, port 32-63 will
be disabled.
SW4900:admin> switchshow
switchName: SW4900
switchType: 44.1
switchState: Online
switchMode: Native
switchRole: Principal
switchDomain: 48
switchId: fffc30
switchWwn: ff:ff:ff:ff:ff:ff:ff:ff
zoning: ON (cfg_em)
switchBeacon: OFF
Area Port Media Speed State
==============================
0 0 id N4 No_Light
1 1 id N4 No_Light
2 2 id N4 No_Light
3 3 id N4 No_Light
4 4 id N4 No_Light
5 5 id N4 No_Light
6 6 id N4 No_Light
7 7 id N4 No_Light
8 8 id N4 No_Light
9 9 id N2 Online F-Port 10:00:00:00:00:00:00:14
10 10 id N2 Online F-Port 10:00:00:00:00:00:00:22
11 11 id N2 Online F-Port 10:00:00:00:00:00:00:18
12 12 id N2 No_Light
13 13 id N2 No_Light
14 14 id N2 No_Light
15 15 id N2 No_Light
16 16 id N2 Online F-Port 10:00:00:00:00:00:00:24
17 17 id N2 Online F-Port 10:00:00:00:00:00:00:16
18 18 id N4 No_Light
19 19 id N2 Online F-Port 10:00:00:00:00:00:00:20
20 20 id N2 No_Light
21 21 id N2 No_Light
22 22 id N2 No_Light
23 23 id N2 No_Light
24 24 id N2 Online F-Port 10:00:00:00:00:00:00:15