EMC VNX Series

EMC
®
VNX
™
Procedure Generator
EMC CONFIDENTIAL version: 4.5
46 of 51
9. [ ] If the Blades are configured as primary and standby, perform a failover test on the Blades in the
replacement enclosure.
If the Blades are not in a failover configuration, proceed to the next step.
a. Determine the Blade failover status using the command below and Table 3:
# /nas/bin/nas_server -info –all
b. To test the failover configuration of the Blades in the replacement enclosure, type the following
command:
# /nas/bin/server_standby <server_name> -activate mover
where <server_name> is the name of the primary Blade.
Use the
nas_server -list command to get the server name.
c. After completing the failover, restore the primary Blade by typing the following command:
# /nas/bin/server_standby <server_name> -restore mover
where <server_name> is the name of the primary Blade. Use the nas_server -list command to
get the server name.
Example:
In a two Blade system, Blade 2 has failed over to Blade 3, its standby. The command to restore Blade 2
as the primary Blade is:
# /nas/bin/server_standby server_2 -restore mover
10. [ ] Verify the Blades have the correct mounts by entering the following commands for each Blade:
# /nas/bin/server_mount <server_name>
where <server_name> is the name of the lowest-numbered Blade in the replacement BE.
Use the
nas_server -list command to get the server name.
11. [ ] Check the fault LED on the front of the BE (Figure 20). If the fault LED is on, go to FRU failures for
information on how to resolve the problem.
Task 12: Installing the Blade Enclosure Front Bezel
The Blade enclosure front bezel must be installed into the Blade enclosure. To install the Blade enclosure
front bezel:
1. [ ] Carefully align the front bezel, by holding the bezel edges, to the two brackets on the front of the
enclosure.