Figure 4-17: Quick buttons
Procedure
1. On the Loop Diagnostics screen, tap Trex Unit Current → More Options → Quick
Button Selection.
More Options does not appear unless the Trex Unit Power or Trex Unit Current is
enabled.
2. Tap one of the Quick Button Selection options.
3. Enter a new value for the button, and tap OK.
4. Repeat until all buttons are set as desired.
5. Tap Back to save the changes and return to the Loop Diagnostics screen.
User Guide Loop Diagnostics application
September 2021
User Guide 145
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
