Emerson AMS Trex Device Communicator - Copy HART Configuration; Rename HART Configuration; Delete HART Configuration

Procedure
1. In the Field Communicator application, tap HART Offline.
2. Tap Offline Config → Edit Existing.
3. Tap the column heading to sort configurations by File Name or Tag. Select the
configuration you want to edit, and tap OK.
4. Select and edit the parameters.
5. Tap the checkbox to mark the parameter for writing.
Note
Unmarked parameters are saved but not sent when you transfer the configuration
to a connected device.
6. Tap Save when you finish editing the parameters.
7. If necessary, enter a new configuration name.
8. Tap OK.
3.15.3 Copy a HART configuration
You can create a copy of a saved configuration.
Procedure
1. In the Field Communicator application, tap HART Offline.
2. Tap Offline Config → Copy.
3. Select the configuration you want to copy, and tap OK.
4. Enter a name for the new copy of the configuration, and tap OK.
5. Tap OK when asked if you want to copy the file.
The configuration is copied and saved to the Trex unit.
3.15.4 Rename a HART configuration
Procedure
1. In the Field Communicator application, tap HART Offline.
2. Tap Offline Config → Rename.
3. Select the file to rename, and tap OK.
4. Enter a new name for the configuration, and tap OK.
5. Tap OK when asked if you want to rename the configuration.
The configuration is renamed.
3.15.5 Delete a HART configuration
Procedure
1. In the Field Communicator application, tap HART Offline.
2. Tap Offline Config → Delete.
User Guide Field Communicator application
September 2021
User Guide 95
w ww . . co m
information@itm.com1.800.561.8187