Figure 5-9: Example of noise spectrum
3. If necessary, tap
Reset Peak to clear the peak on the spectrum.
5.12 Settings
Within the Fieldbus Diagnostics application, you can change the following settings:
• View or hide the minimum, maximum, and average values for each measurement.
• View or hide the host and device tags.
• Set the number of measurements to average.
• Set the minimum and maximum acceptable values for each type of measurement. This
defines the range of values for the measurements labeled GOOD, BAD, and CHECK on
the Fieldbus Diagnostics Overview screen.
• Reset all settings in the application to the default values.
User Guide Fieldbus Diagnostics application
September 2021
User Guide 167
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
