Emerson AMS Trex Device Communicator - View Device Alerts; Send Configuration to Connected HART Device; Save Configuration from HART Device

3.14.7 View device alerts
Procedure
1. Connect to a HART device.
2. If the device has alerts, tap Alerts at the top of the screen.
The list of alerts is displayed.
Figure 3-34: Alerts button
3. Tap OK.
3.14.8 Send a configuration to a connected HART device
Prerequisites
You must have at least one configuration saved in the Trex unit for the connected device
type.
Procedure
1. Connect to the HART device.
2. Tap the Menu tab in the application bar.
3. Tap Send Config.
4. Select a saved configuration, and tap OK.
5. Review the parameters, and tap Send.
3.14.9 Save a configuration from a HART device
You can save a copy of the configuration from the connected device. The configuration
has only non-dynamic parameters.
Procedure
1. Connect to the HART device.
2. Tap the Menu tab.
3. Tap Save Config.
4. Enter a filename for the configuration, and tap OK.
The configuration is saved in the Trex unit.
User Guide Field Communicator application
September 2021
User Guide 93
w ww . . co m
information@itm.com1.800.561.8187