Note
The selected tag is not retained the next time you connect to the device. You need to
select the desired tag each time you connect the device.
If you want to change the value of the HART tag, see the device documentation for more
information. The location of these tag parameters varies because it is determined by the
device manufacturer.
Procedure
1. Connect to the HART device.
2. Tap the tag that is displayed on the top of the screen.
Figure 3-33: Tap the device tag
3. Select Tag or Long Tag.
The displayed tag changes.
Field Communicator application User Guide
September 2021
92 User Guide
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
