1 Introduction
1.1 General
Welcome to the Daniel 3410 Series Ultrasonic Retrofit Instruction Manual.
This manual has been designed to provide you with a step-by-step set of instructions for
retrofitting a Daniel Gas Ultrasonic meter with Mark III electronics to the new 3410 Series
electronics.
Notice
Please read the “Before You Begin” section to make sure you have all the components
necessary to perform the retrofit before taking the meter out of service.
Important
If retrofitting from Mark II electronics to 3410 Series electronics complete Sections 3 and 4
in the Daniel Ultrasonic Mark III Upgrade Kit Instructions P/N 3-9000-746 to determine the
communications and output settings of the Mark II electronics. Use those settings and the
instructions in this manual to configure the 3410 Series electronics.
Upgrade kit instructions Introduction
P/N 3-9000-784 July 2019
3410 Series Electronics Upgrade kit instructions 13
To Next Page
Loading...
