Contents
Part I Plan
Chapter 1 Introduction.................................................................................................................13
1.1 General...........................................................................................................................................13
Chapter 2 Before you begin..........................................................................................................15
2.1 Required parts................................................................................................................................15
2.2 Tools required................................................................................................................................ 15
Chapter 3 Before removing the Mark III Electronics...................................................................... 17
3.1 Procedure before removing the Mark III Electronics........................................................................17
Chapter 4 Removing Mark III Electronics...................................................................................... 23
4.1 Procedure to remove the Mark III Electronics..................................................................................23
Part II Install
Chapter 5 Installing the 3410 Series Electronics............................................................................29
5.1 Procedure to install the 3410 Series Electronics.............................................................................. 29
Part III Operate
Chapter 6 Configure the 3410 Series Electronics...........................................................................47
6.1 Initial communication connection using Ethernet...........................................................................47
6.2 Initial communication connection using RS-232 Serial....................................................................48
6.3 Write the converted configuration file to the meter........................................................................52
6.4 Configure the meter using the Field Setup Wizard..........................................................................56
Appendix A Mark III Wiring I/O and switch settings.........................................................................61
A.1 Mark III RS-232 Full Duplex............................................................................................................. 63
A.2 Mark III RS-485 Half Duplex............................................................................................................ 64
A.3 Mark III Discrete output switch settings..........................................................................................65
A.4 Mark III RS-232 Full Duplex............................................................................................................. 66
A.5 Mark III RS-485 Half Duplex............................................................................................................ 67
A.6 Mark III Series 100 option board (if installed).................................................................................. 67
A.7 Mark III RS-232 Full Duplex............................................................................................................. 68
A.8 Mark III RS-485 Half Duplex............................................................................................................ 69
A.9 Mark III Series 100 plus HART option board (if installed)................................................................. 69
Appendix B Communication/Output settings..................................................................................71
B.1 Summary table of communications/output settings.......................................................................71
Appendix C 3410 Communication and Output settings................................................................... 75
Upgrade kit instructions Contents
P/N 3-9000-784 July 2019
3410 Series Electronics Upgrade kit instructions ix