2. Use the Driver selection pull-down menu if communication settings require RS-485
Figure 6-3: Change driver selection for RS-485 half duplex or full duplex
communication
6.3 Write the converted configuration file to the
meter
Important
If the Mark III electronics contained keys, the user needs to ensure the same keys are
enabled in the 3410 electronics prior to writing the convereted configuration. Otherwise,
some configuration points may not be able to be written.
Configure the 3410 Series Electronics Upgrade kit instructions
July 2019 P/N 3-9000-784
52 3410 Series Electronics Upgrade kit instructions
To Next Page
Loading...
