Emerson Daniel Ultrasonic 3410 Series

Table B-1: Communications/output settings summary table (continued)
Output Type (Check electronics switch settings and circle
appropriate box for each output)
Digital Output 2B Not Used
(if J5-2 not
used)
TTL (if S9-2
is set to
TTL)
Open
Collector (if
S9-2 is set
to OC)
Frequency Output 1B Not Used
(if J5-1 not
used)
TTL (if S8-4
is set to
TTL)
Open
Collector (if
S8-4 is set
to OC)
Frequency Output 2A Not Used
(if J5-6 not
used)
TTL (if S9-3
is set to
TTL)
Open
Collector (if
S9-3 is set
to OC)
Frequency Output 2B Not Used
(if J5-5 not
used)
TTL (If S9-4
is set to
TTL)
Open
Collector (if
S9-4 is set
to OC)
Analog Input 1 Not used (if
J12-1 not
used)
Source (if
S12 is set
to SRC)
Sink (if S12
is set to
SINK)
Analog Input 2 Not Used
(if J12-3
not used)
Source (if
S13 is set
to SRC)
Sink (if S13
is set to
SINK)
Analog Output 1 Not Used
(if J11 not
used)
Source (if
S14 is set
to SRC)
Sink (if S14
is set to
SINK)
Analog Output 2 (HART Capable) Not Used
(if J10 not
used)
Source (if
S15 is set
to SRC)
Sink (if S15
is set to
SINK)
Enter the results of the 3400 Summary Table of Communications/output settings in the
table below as a quick reference to setup the 3410 Series meter configuration parameters.
Table B-2: Communications/output settings summary table results
Output Type Enter communications and output settings
Serial Port A
Serial Port B
Serial Port C
(1)
Digital Output 1A
Digital Output 1B
Frequency Output 1A
Digital Output 2A
Digital Output 2B
Communication/Output settings Upgrade kit instructions
July 2019 P/N 3-9000-784
72 3410 Series Electronics Upgrade kit instructions