• It is critical that you keep the filter inputs routed away from
any electrical noise sources to prevent noise from being
induced into them and carried out of the enclosure.
Cable to Enclosure Shielding
Shielded motor, feedback, serial communications and external
encoder cables were used for EMERSON Motion Control’s
compliance testing and are necessary to meet the EMC
requirements. Each cable shield was grounded at the enclosure
wall by the type of grommet described earlier and shown in the
figure below.
Figure 2: Through Wall Shield Grommet
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
