10 DIN IPG215D Panel Mounting and Wiring Panel Mounting and Wiring • 9
2 Panel Mounting and Wiring
In most situations the I/O Module PLC will be factory-mounted and wired inside an Emerson UL listed industrial control
panel. Installers need only to make field connections for the panel’s supply power and any input or output wiring that is
being used specific to the installation.
2.1 10 DIN IPG215D Panel Mounting and Wiring
The 10 DIN I/O Module controller panel is Emerson
P/N 851-4445. The panel provides the I/O Module PLC
and Visograph display already factory mounted, wired and
ready for field connection to loads and inputs. The panel
also includes an E2E RX300 controller and 10 toggle
switches to be used for dual temperature refrigeration
cases. The toggle switches are factory-mounted and wired
to the I/O Module digital inputs and are used to signal to
E2E the temperature mode for dual temperature
refrigeration cases to run in. The panel dimensions
(16 5/16” W, 20 3/8” L, 6” D) are shown in Figure 2-1.
The panel has four (4) screw holes for easy mounting. The
dimensions of the mounting holes center to center are
shown in Figure 2-2. The panel mounting screws should
be set in a high strength construction material such as a
lumber stud, metal stud, or concrete/block/masonry with
anchor.
Figure 2-1 - 10 DIN E2E Panel Mounting
Figure 2-2 - 10 DIN E2E Panel Wiring
To Next Page
Loading...
