16 • iPro I/O Module Installation and Operation Manual 026-1741 Rev 0
3 Navigating
Visograph
Display
The Visograph display is used to view the status of inputs
and outputs, toggle refrigeration circuit overrides and edit
BACnet MS/TP network settings. There are eight (8) keys,
T1-T8, along the bottom of the display that are used to
navigate the display.
3.1 Accessing Status
Screen
The main screen is the Analog Inputs screen where there
are shortcut keys to access other the other status screens
quickly. The analog inputs status screen shows the current
value of each of the analog inputs. If an input is not
configured from E2E then a “not used” label will appear
in place of the sensor value. If a sensor is configured but in
error, an AI Error message will appear in place of the
sensors value. The shortcut keys are also available from all
other screens as well for quick navigation.
DI Shortcut
Press T2 key to access the digital input status screen. This
gives an overview of the value of each of the digital
inputs. For the 10 DIN model, the T8 key can be used to
page over to see additional digital input values.
Relay Shortcut
Press the T3 key to access the relay output status screen.
This screen gives an overview of the value of each of the
relay outputs. For the 10 DIN model, the T8 key can be
used to page over to see additional relay outputs.
Figure 3-1 - Navigating Visograph Display
Figure 3-2 - Visograph Main Status Screens
Figure 3-3 - Visograph Digital Input Screen
To Next Page
Loading...
