20 • iPro I/O Module Installation and Operation Manual 026-1741 Rev 0
3.5 Performing a Backup
The I/O Module has the capability to back up all
parameters to a backup file and transfer to the file to a
USB. This feature can be helpful during a replacement
device scenario or any time a quick parameter
configuration is needed.
1. From the Main Menu use the T4/T6 keys to
arrow down to 3. Backup and press T5 SET key
to enter the menu.
2. Use the T5 SET key to enter edit mode on
Backup Setpoints, use T4/T6 to change the
value to YES. The Backup in progress message
will appear.
3. Once the backup is complete the display will
show Backup Successful, Press USB to
Transfer Backup File to USB. Press T8 to start
the USB transfer.
4. The I/O Module will search for connected USBs,
and if no USB is detected, it will prompt the user
to insert a USB drive.
5. Once the USB drive is inserted, the screen will
prompt the user to press the USB button. Press
T8 USB to copy the backup to USB drive.
Figure 3-13 - Visograph Backup
Figure 3-14 - Visograph Backup in Progress
Figure 3-15 - Visograph Transfer Backup to USB
Figure 3-16 - Visograph Transfer Backup - Insert USB
Figure 3-17 - Visograph Transfer Backup - Save
To Next Page
Loading...
