Configuration and Use Manual 69
Required Configuration Optional ConfigurationUsing the TransmitterFlowmeter Startup
Chapter 8
Optional Configuration
8.1 Overview
This chapter describes transmitter configuration parameters that may or may not be used, depending
on your application requirements. For required transmitter configuration, see Chapter 6.
Table 8-1 lists the parameters that are discussed in this chapter. Default values and ranges for the most
commonly used parameters are provided in Appendix A.
Table 8-1 Configuration map
Tool
Topic Subtopic ProLink II Communicator Display Section
Volume flow
measurement for gas
✓ 8.2
Special
measurement units
Mass flow ✓✓ 8.3
Volume flow ✓✓
Gas standard volume flow ✓
Cutoffs ✓✓ 8.4
Damping ✓✓ 8.5
Flow direction ✓✓ 8.6
Events ✓✓ 8.7
Slug flow ✓✓ 8.8
Fault timeout ✓✓ 8.9
Status alarm severity ✓✓ 8.9.1
Display functionality
(1)
Update period ✓✓ ✓8.10.1
Display language ✓✓8.10.2
Totalizer start/stop ✓✓ ✓8.10.3
Totalizer reset ✓✓ ✓
Auto scroll ✓✓ ✓
Scroll rate ✓✓ ✓
Offline menu ✓✓ ✓
Password ✓✓ ✓
Alarm menu ✓✓ ✓
Ack all ✓✓ ✓
Backlight on/off ✓✓ ✓8.10.4
Backlight intensity ✓✓
Display variables ✓✓ 8.10.5
Display precision ✓✓
To Next Page