Emerson numatics g3 series - G3 Graphic Display

G3SeriesPROFIBUS‐DPTechnicalManual
Page 18
TDG3PTTM1-2EN 02/09
Subject to change without notice
www.numatics.com/g3
G3 Graphic Display
The G3 Communication and I/O modules have an integrated graphic display that may be used to configure the
parameters of the modules as well as showing diagnostic information.
The following graphic displays represent the main menu selections of the DeviceNet communication module
(node). Use the NEXT button to scroll through the Main menu headings shown below. At this level pressing
the SET button allows access the Sub-Menus. Please see the appropriate pages referenced below for further
details and descriptions of the Sub-Menus.
NOTE: WHEN A NETWORK I/O CONNECTION IS
ESTABLISHED MANUAL CHANGES TO NODE PARAMETERS ARE NOT ALLOWED!
Seepage19
forSub‐Menu
Seepage21
forSub‐Menu
Seepage22
forSub‐Menu
Seepage20
forSub‐
M
enu
Seepage23
forSub‐Menu
ADVANCED
SETTINGS
ADDRESS
126
DIAGNOSTICS
FACTORY
D
EFAULTS
PROFIBUSDPSSALOCK
DISABLED
Home Screen