Emerson numatics g3 series - SSA LOCK Sub-Menu

G3SeriesPROFIBUS‐DPTechnicalManual
Page 20
TDG3PTTM1-2EN 02/09
Subject to change without notice
www.numatics.com/g3
SSA LOCK Sub-Menu
Steps to Set SSA (Set Slave Address) LOCK
1. Press the SET button to enter the SSA Lock sub-menu.
2. Press the NEXT button to enable / disable the SSA Lock
a. ENABLE
-
allows the address to be set only through the G3 graphic
display
b. DISABLE
-
allows the address to be set through either the G3 graphic
display or software
c. RETURN (this will return you to the top of SSA LOCK menu)
Press the SET button to confirm your choice.
3. Press the NEXT button to select
Yes or No to accept the setting
a. Selecting
No will bring you back to the main SSA LOCK menu.
b. Selecting
Yes will take you to the following SAVE SETTINGS menu.
Press the SET button to confirm your choice
Saved Setting Steps
4. Press the NEXT button to select either NOW or LATER.
a. Selecting NOW will cause the node to reset and apply the new setting.
b. Selecting LATER will cause the setting to be saved in temporary
memory to allow you to make additional parameter changes before the
node is reset. However, you must ACCEPT the saved changes before
your next power cycle otherwise they will be lost.
Press the SET button to confirm your choice.
SSA LOCK
DISABLED
SSA LOCK
ENABLE
SSA LOCK
DISABLE
SSA LOCK
RETURN
ACCEPT
ENABLED Y N
ACCEPT
ENABLED Y N
SAVE SETTINGS
NOW LATER