G3SeriesPROFIBUS‐DPTechnicalManual
Page 7
TDG3PTTM1-2EN 02/09
Subject to change without notice
www.numatics.com/g3
Manifold Connectors
Solenoid Coil Connections using Z-Board
TM
Technology for 2005/2012/2035 valve series
Z-Board
™
plug together technology connects all valve solenoids to the valve coil output driver board,
located in the valve adapter. The 32 available coil outputs are divided into 2 separate connector groups.
Output group No. 1 is comprised of the first output word, bits 0-15, and output group No. 2 is comprised of
the second output word, bits 16-31. Output group No. 1 connects directly to the Z-Boards
™
. Output group
No. 2 is connected to the Z-Boards
™
via an internal ribbon cable or valve side Sub-D module. The first
output (bit 0) connects to the “14” (A) solenoid on the valve closest to the communication node. The 17
th
–
32
nd
solenoids interconnect via the Z-Boards
™
to output group No. 2. For the maximum capability of 32
solenoids on the same manifold, the 16
th
and 17
th
solenoid coils must NOT be on the same sub-base.
DOUBLE
"Z-BOAR D"
SINGLE
"Z-BOARD"
DOUBLE
"Z-BOARD"
SINGLE
"Z-BOARD"
14(A) Solenoid Pin No. 1
Earth Ground Pin No. 3
12(B) Solenoid Pin No. 2
Common Pin No. 4
Plug-in Manifold with
Intergral "Z-Board"
Eliminates Wiring
Output Group
No. 1
Output Group
No. 2
A single solenoid valve’s coil is always on the “14” end.
NOTE!
To Next Page
Loading...
