Emerson numatics g3 series - Diagnostics Continued

G3SeriesPROFIBUS‐DPTechnicalManual
Page 24
TDG3PTTM1-2EN 02/09
Subject to change without notice
www.numatics.com/g3
Diagnostics Continued
DIAGNOSTICS
USNW POWER
24 VOLTS
FIRMWARE REV.
2.10
BOOTCODE REV.
1.0
PART NUMBER
240-239
1. All diagnostic information is read only
2. Press the SET button to enter DIAGNOSTICS sub-menu.
3. Press the NEXT button to scroll through the main diagnostic menu choices.
a. UNSW POWER
. - Displays voltage level of unswitched power (Node & Inputs)
b. NETWORK ERRORS - ERROR CODE
. - Displays fieldbus network errors
c. CURRENT COMM. EVENT NUMBER
. - Displays
d. SHOW LOGGED COMM. EVENTS
. - Displays log of network errors
e. CURRENT SUBBUS ERROR
. - Displays sub bus errors
f. SHOW LOGGED SUBBUS ERRORS
. - Displays log of sub bus errors
g. FIRMWARE REV.
. - For service personnel
h. BOOTCODE REV.
. -For service personnel
i. PART NUMBER
. - Displays replacement part number of module
 The UNSW POWER screen indicates the voltage level present on the UNSW
(Node & Input) power pins (Pin No. 2 and 3) of the main power connector.
 A voltage level less than 19 volts will generate an error screen and an
associated diagnostic bit (see ‘Diagnostic’ section for more details).
NOTE!
NETWORK ERRORS
ERROR CODE - #
CURRENT COMM.
EVENT - #
SHOW LOGGED
COMM. EVENTS
CURRENT SUBBUS
ERR - #
SHOW LOGGED
SUBBUS ERRORS