G3SeriesPROFIBUS‐DPTechnicalManual
Page 19
TDG3PTTM1-2EN 02/09
Subject to change without notice
www.numatics.com/g3
Network Address Sub-Menu
ADDRESS
111
SET ADDRESS
111
SET ADDRESS
111
ACCEPT
111 Y N
ACCEPT
111 Y N
SAVE SETTINGS
NOW LATER
Steps to Set Address
1. Press the SET button to enter the ADDRESS sub-menu.
2. Press the NEXT button to scroll through the choices for the hundreds digit of
the node address.
Press the SET button to select the hundreds digit and move into the tens digit
selection.
3. Press the NEXT button to scroll through the choices for the tens digit of the
node address.
Press the SET button to select the tens digit.
Change the ones digit using the same procedure.
4. Press the NEXT button to select
Yes or No to accept the address shown on the
display,
a. Selecting
No will bring you back to the main Address menu.
b. Selecting
Yes will take you to the following SAVE SETTINGS menu.
Press the SET button to confirm your choice.
5. Press the NEXT button to select either NOW or LATER.
a. Selecting NOW will cause the node to reset and apply the new
setting.
b. Selecting LATER will cause the new Address to be saved in
temporary memory to allow you to make additional parameter
changes before the node is reset. However, you must ACCEPT the
saved changes before your next power cycle otherwise they will be
lost.
Press the SET button to confirm your choice.
Only addresses 0- 126 are valid.
Address 126 is the Factory Default node address.
NOTE!
To Next Page
Loading...
