Emerson numatics g3 series - Analog I;O Modules; 4 Channel I;O - M12 Female Modules

G3SeriesPROFIBUS‐DPTechnicalManual
Page 44
TDG3PTTM1-2EN 02/09
Subject to change without notice
www.numatics.com/g3
Analog I/O Modules
Analog I/O Module Rules
The analog I/O modules follow the same rules as the digital I/O modules. The maximum total number of
modules on the Sub-Bus is 16. The analog modules allow the user to control and/or read analog devices using
an analog signal. These modules are available in two analog signal types: 0-10 V and 4-20 mA, and are available
in two different I/O configurations: 2 analog input channels/ 2 analog outputs channels (2AI/2AO) or 4 analog
input channels (4AI).
4 Channel I/O - M12 Female Modules
Specifications
- Input Resolution: 16 bit (65,536 Counts)
- Output Resolution: 16 bit (65,536 Counts)
- Settling Time: 3 ms Max
- Absolute Precision: ≤ 1.0% of Signal
- Voltage Input Impedance: 0-10VDC – 40K Ohms
- Current Input Impedance: 250 Ohms
- Input Cutoff Frequency: 100 Hz
Module
Part No.
Signal Type Input Points Output Points Short Circuit Protection
240-212 0 - 10V 4 0
240-213 0 - 10V 2 2
240-214 4 - 20mA 4 0
240-215 4 - 20mA 2 2
Yes