Emerson numatics g3 series - MCM - Manual Configuration Module (Optional)

G3SeriesPROFIBUS‐DPTechnicalManual
Page 26
TDG3PTTM1-2EN 02/09
Subject to change without notice
www.numatics.com/g3
MCM – Manual Configuration Module (Optional)
The MCM is an optional module that is installed between the node and the valve adapter module and allows
the user to manually set, via DIP switches, the node address without the need for software configuration or the
use of the integrated graphic display in the node. If software configuration or configuration via the integrated
graphic display in the node is preferred, this module is not necessary.
Description Replacement Part Number
Complete Module 240-186