Emerson numatics g3 series - Advanced Settings - Brightness

G3SeriesPROFIBUS‐DPTechnicalManual
Page 21
TDG3PTTM1-2EN 02/09
Subject to change without notice
www.numatics.com/g3
Advanced Settings - Brightness
ADVANCED
SETTINGS
ADVANCED MENU
SET BRIGHTNESS
SET BRIGHTNESS
LOW
SET BRIGHTNESS
MEDIUM
SET BRIGHTNESS
HIGH
SET BRIGHTNESS
RETURN
Brightness Settings
1. Press the SET button to enter the ADVANCED SETTINGS menu.
2. Press the NEXT button to scroll to the CONFIG MENU / SET
BRIGHTNESS.
Press the SET button to enter the CONFIG MENU / SET BRIGHTNESS.
3. Press the NEXT button to scroll the choices for the desired brightness of the
LCD display for all modules on the G3 system.
a. LOW
b. MEDIUM
c. HIGH (Factory Default)
d. RETURN (this will return you to the SET FAULT/IDLE menu)
Press the SET button to confirm your choice.
The changes will take effect immediately.
 This a global setting that affects all modules
 Each module, however, has its own setting if different settings
are required.
NOTE!