2. Navigate to the save location for the configuration file, give the file a name, and
select Save. The configuration will be saved as a “.smv” file type.
Sending a saved configuration
Procedure
1. To send a saved configuration, open Engineering Assistant in offline mode and
select File>Open.
2. Navigate to the saved .smv file to be sent. Select Open.
3. The Engineering Assistant Device Connection screen will appear, see Figure 2-12.
4. Select the Search button located in the lower right corner of the screen.
Engineering Assistant will begin to search for connected devices.
5. When the search is completed, select the device to communicate with and select
Send Configuration button.
6. Once the configuration is finished being sent to the device, a notification appears.
7. If finished with the configuration process, close Engineering Assistant.
2.4.9
Other fluid configurations
Natural gas AGA No. 8 detail characterization or ISO 12213,
molar composition flow configuration
Procedure
1. Expand the Gas category.
2. Expand the Natural Gas category.
3. Select AGA Report No. 8 Detail Characterization Method or ISO 12213, Molar
Composition Method.
4. Select Next > to proceed to the Fluid Composition tab. Figure 2-13 shows an
example of the Fluid Composition tab for AGA Report No. 8 Detail Characterization
Method. The ISO 12213, Molar Composition Method Fluid Composition tab will
require the same information.
Reference Manual Configuration
00809-0100-4803 October 2018
Emerson.com/Rosemount 25
To Next Page
Loading...
