Figure 2-12: Engineering Assistant Device Connection Screen
3. Select the Search button located in the lower right corner of the screen.
Engineering Assistant will begin to search for connected devices.
4. When the search is completed, select the device to communicate with and select
Send Configuration button.
5. Once the configuration is finished being sent to the device, a notification appears.
6. If finished with the configuration process, close Engineering Assistant.
Note
After the configuration is sent to the device, saving the configuration file is
recommended. For more information on saving a configuration file, see Saving a
configuration.
Sending a configuration in online mode
Procedure
1. To send the configuration, select the Send button. Once the configuration is
finished being sent to the device, a notification appears.
2. If finished with the configuration process, close Engineering Assistant.
Note
After the configuration is sent to the device, saving the configuration file is
recommended. For more information on saving a configuration file, see Saving a
configuration.
Saving a configuration
Procedure
1. To save the configuration, select the Save button.
Configuration Reference Manual
October 2018 00809-0100-4803
24 Rosemount 3051S Multivariable Transmitter
To Next Page
Loading...
