Figure 2-11: Save/Send Configuration Tab (Offline Mode)
2. Select the icon above each window to be taken to the appropriate screen to edit the
configuration information. To return to the Save/Send tab, select Save/Send in the
left menu.
3. When all information is correct, see Sending a configuration in offline mode or
Sending a configuration in online mode.
Note
The user will be notified if the configuration has been modified since it was last sent
to the transmitter. A warning message will be shown to the right of the Send Flow
Data and/or Send Device Data check boxes.
Sending a configuration in offline mode
Procedure
1. To send the configuration, select the Send To button.
Note
The Send Flow Data and/or Send Device Data check boxes can be used to select
what configuration data is sent to the transmitter. If the check box is unselected,
the corresponding data will not be sent.
2. The Engineering Assistant Device Connection screen will appear, see Figure 2-12.
Reference Manual Configuration
00809-0100-4803 October 2018
Emerson.com/Rosemount 23
To Next Page
Loading...
