Figure 2-33: Energy Rate Custom Units - Energy and Time Conversion Example
• Under the Low Flow Cutoff heading, edit the current Minimum DP Value as needed.
The unit for this value is the user-selected DP unit. If the measured DP value is less than
the minimum DP value, the transmitter will calculate the energy value to be zero.
• The Sensor Limits and Minimum Span can be viewed under the Energy Rate Sensor
Limits heading.
2.7.3
Totalizer
About this task
Mass and energy flow Fast Keys
1, 4, 1, 3
(Fully compensated mass and energy flow feature board only)
The Totalizer tab is used to configure the settings associated with the totalizer
functionality within the transmitter.
Reference Manual Configuration
00809-0100-4803 October 2018
Emerson.com/Rosemount 53
To Next Page
Loading...
