3. Pass the cable through the cable gland/conduit.
4. Connect the cable wires:
a) For the 3101, connect wires according to the Figure 4-1.
b) For the 3102, connect wires according to the Figure 4-2.
c) For the 3105, connect wires according to the Figure 4-3.
5. Connect the cable shield/screen to a suitable ground (earth) at one
end only.
6. Replace the cover, tighten the cable gland, and connect the power
supply.
4.2 Mounting the transmitter above a liquid surface
A two-in. thread is provided to mount the transmitter. The thread form is
either BSPT or NPT, and is clearly marked on the hexagon of the transmitter
body.
To help with an installation, flange accessories and bracket kits are available
from Emerson. The accessory flanges supplied are manufactured from PVC
and are a full face design. Care must be taken when installing to raised face
mating flanges on the tank or vessel to prevent distortion of the PVC flange
by overtightening the bolts (see Installing in a tank with a nozzle or stand-
off).
Refer to the Rosemount 3101, 3102, and 3105 Product Data Sheet for
accessory ordering information.
4.2.1 Bracket mounting
The bracket kit contains a stainless steel angle bracket and PVC threaded
disc, which may be used to mount the transmitter on a support over the
liquid surface.
Quick Start Guide August 2019
14 www.emerson.com
To Next Page
Loading...
Need help?
General
