3.5 Explanation of the groups
The alarm panel will group motion sensors and door/window sensors into 5 security
types, each assigned according to the owner’s application need.
Explanation of the groups
• Security Type “0”: in-Home group. The sensor will be activated only when the
system is in Full security mode . This sensor will not be activated when set to
in-Home mode . When sensor is triggered in Full security mode the siren will
be triggered immediately without any delay.
Example: A PIR motion detection sensor installed in your living room.
• Security Type “1”: in-Home and Normal group. The sensor will be activated
when the system is in either in-Home mode or Full security mode . When
sensor is triggered in-Home or Full security mode the siren will be triggered
immediately without any preset delay.
Example: A door/window sensor.
• Security Type “2”: in-Home group + Delay. Same as Security Type “0” except
when sensor is triggered the siren will be triggered after a configured Entry/Exit
delay time. This is mostly used for main entrance to prevent accidental
triggering of the alarm by the user when arming or disarming the alarm.
Example: a PIR in the corridor facing the front door.
• Security Type “3”: in-Home and Normal group + Delay. Same Security Type
“1” except when sensor is triggered the siren will be triggered after a configured
Entry/Exit delay time. This is mostly used for main entrance to prevent
accidental triggering of the alarm by the user when arming or disarming the
alarm.
Example: A door/window sensor installed on the front door
• Security Type “4”: 24Hrs intruder: the sensor will immediately trigger an
alarm regardless whether the system is in Disarm , Fully or in-Home
mode. This is normally used to protect areas 24/7 from unauthorized access as
safe box, electrical maintenance room etc.
Example: A door/window sensor installed on a safe box
To Next Page
