text 2. You will receive a text message to confirm the system is armed (System home
mode).
8.3.4 By voice call alert
During an alarm condition the alarm panel will initiate a voice call session, during
which it will repeatedly dial the preset voice call telephone numbers in sequence.
• For each contact called the alarm message will playback repeatedly for 30
seconds. The next contact will then be called.
• Each contact will be called 3 times in a call loop regardless whether the call is
answered or not.
• To end the current call, press the “*” key then “#” key on the phone, or wait 30
seconds timeout. The alarm panel will then call the next contact on the list.
• To exit from the call loop, press the “*” key then “8” key. This contact will not be
called again until the next alarm condition.
• If 3 contacts exit the call loop (i.e. 3 contacts entered “*” then “8” key), the entire
call session will end abruptly.
Phone control mode
When called, the user may press the “*” key on the phone. This will stop the
siren and the panel will enter phone control mode to wait for next input key:
a. Press “1” key = Fully Arm and send SMS
b. Press “2” key = Part-Arm and send SMS
c. Press “3” key = Set the Siren to turn on Alarm and send SMS
d. Press “4” key = Set the Siren to turn off Alarm and send SMS
e. Press “6” key = Listen to the Alarm message again
f. Press “7” key = Enter Listen-In Mode. This mode will timeout after 5 minutes.
Press the “#” to exit Listen-In at any time.
g. Press “8” key = Exit from call loop and send SMS
h. Press “9” key = Enter Two Way Talk Mode. This mode will timeout after 5 minutes
i. Press “0” key = Disarm and send SMS
j. Press “#” key = Cancel this call without exiting the call loop.
If no keys are input after 30 seconds, the alarm panel will hang up.
To Next Page
Loading...
