3. Enter PIN + 15 + to start the binding process. The DISARM LED will beep
once and start to blink for 30 seconds.
4. Within 30 seconds, press a button on the remote.
5. For RFID tags, simply swipe it in front of the alarm
panel in the area above the siren.
6. If a device is successfully added, the DISARM LED will turn on for 1 second
along with a long beep.
7. If the binding process fails, it will timeout after 30 seconds and 3 short beeps will
be heard.
8. To exit the binding process, press the key
4.3 Add an indoor wireless siren
First check if the wireless siren communication is enabled.
Enter PIN + 04 + and check if the 0 LED is ON (if the 0 LED is OFF press the “0” to
enable the communication) confirm with the button.
Enter the pairing mode of the siren by pressing the pairing button approx. 3 seconds
until you hear a confirmation beep.
Now enter the PIN + key the siren is paired successfully when you hear a beep from
the wireless siren.
To activate the indoor wireless siren, close the battery compartment the activation is
confirmed by the flashing LEDs on the indoor wireless siren.
To Next Page
Loading...
