5.7 Deleting all RFID tags
1. On the alarm panel, enter the PIN + key to disarm the system.
2. Enter PIN + 20 + 3 +
5.8 Delete a RFID tag from 1-9
First define the RFID tag number you wish to delete. In this example we want to delete
RFID tag 3.
1. On the alarm panel, enter the PIN + key to disarm the system.
2. Enter PIN + 20 + 3 + 3 + (the 2 should be replaced with the remote number
assigned to the remote you wish to delete).
5.9 Deleting all RFID tags after 9
1. On the alarm panel, enter the PIN + key to disarm the system.
2. Enter PIN + 20 + 3 + 0 +
6.0 How does the Alarm system communicate
The Alarm system can communicate in 2 different ways with your phone.
• Send and receive text messages using the mobile network (SIM card
required).
• Call your phone (SIM card required).
6.1 Alarm notifications
The alarm system will check the programmed phone numbers one by one. Firstly, the
alarm system will send a text message one by one to the programmed phone
numbers. When this is fulfilled the alarm system will start calling the programmed
phone numbers. If one of the phone number has the voicemail enabled the system will
continue to call the next phone number.
Between every text message and phone call there will be a time span of
approximately 15 seconds (depending on additional voicemail duration).
SMS 1
SMS 2
SMS 3 → TEL 1 →TEL 2 → TEL 3 → TEL 4→ TEL 5
SMS 4
SMS 5
If the alarm system is switched off during the notification process the alarm system will
stop sending/calling the remaining phone numbers. For example: Phone number 2
receives a text message notification and switches off the alarm system via the APP
phone number 3 will not receive a text message.
To Next Page
Loading...
