Note: During the registration process be sure no other sensor is triggered. If a motion
detector is in the same room make sure you cover the motion detector or place the
motion detector temporarily in a different room.
11.2 Installation tips
It’s recommended to install the sensor on the frame (no movement) and to install the
magnet on the door/window itself.
Note: The flat sides of the sensor and magnet must face each other, the rounded
sides are the outside of the sensor and magnet. The red LED lights up each time the
door / window is opened or closed!
The distance between the sensor and the magnet must not exceed 1cm. Mount both
parts with the supplied double-sided tape. You can also choose to mount the sensor
by using screws.
It’s not recommended to install the sensor in a room with a lot of metal. Neither mount
the sensor on metal constructions. Always check if the red LED will turn on when the
door/window is opened.
To Next Page
Loading...
