The window/door contact is paired with Zone 1. The motion detector is paired with
Zone 2.
The supplied remote controls and RFIDs are already paired to the system.
For more information about zones please see chapter “Change Sensor (zone) name”
4.0 Adding accessories/sensors
4.1 Adding motion, door/window sensor.
When a new sensor is added it needs to be assigned to a Security Type as
described in chapter Explanation of the groups.
To add a sensor:
1. Power on the sensor by inserting its batteries.
2. On the alarm panel, enter the PIN + Key to disarm the system.
3. Enter PIN + 15 + Security Type + to start the binding process. The DISARM
LED will start to blink for 30 seconds and beep once.
4. Within 30 seconds, set the sensor to enter binding mode using its learn-
key/tamper button.
5. If a sensor is successfully added, the DISARM LED will turn on for 1 second
along with a long beep. The Keypad LED will turn on to indicate the allocated
zone number. (Numbers 1 – 9 for zones 1 – 9, Number 0 for Sensor Zones 10
or higher).
6. If the binding process fails, it will timeout after 30 seconds and 3 short beeps will
be heard.
7. To exit the binding process, press the Key
Note: The first accessory registered is assigned to zone 1, the second accessory
registered is assigned to zone 2, etc. Zones 1 to 9 can be renamed. Zones 10 to 100
cannot be renamed. It is advised to label a sensor with its zone number immediately
after successfully binding it.
4.2 Adding a remote control and RFID tags.
To add these devices:
1. Power on the device by inserting its batteries (not needed for the RFID tag).
2. On the alarm panel, enter the PIN + key to disarm the system.
To Next Page
Loading...
