Eminent EM8710 - Command Overview; Touch Panel Commands

33 | ENGLISH
12.4 Window/door contact
Power supply
4,5V DC (3 x AAA 1,5V)
Stand-by current
<8uA
Alarm current
<12mA
Wireless reach
Max. 150 meter (open field)
Frequency sensors
868MHz
Two-way communication
Open door/window notification
Temperature
-10 to 55 degrees Celsius
Humidity
< 85% (no condensing)
Dimensions sensor WxHxD
29 x 120 x 21 mm
Dimensions magnet WxHxD
15 x 45 x 15 mm
13.0 Command overview
13.1 Touch panel commands
Function
Enter Key
Explanation
External
Wireless
Siren
Setting
Enter PIN code + 04 +
Key 0 on the touch panel indicates if the
external siren communication is enabled or
disabled
- When Enabled: Key 0 LED is on
- When Disabled: Key 0 LED is off (Wireless
Siren communication is Disabled)
Press “0” to toggle enable/disable. Press
to save settings.
RF Anti-
Jamming
Detection
Enter PIN code + 05 + 1 +
Turn On
Enter PIN code + 05+ 2 +
Turn Off
Change PIN
code
Enter old PIN code + 06 + new
PIN code +
Default PIN code: 1234
Key Tone
Enter PIN code + 07 + 1 +
Turn On
Enter PIN code + 07 + 2 +
Turn Off
Open Door /
Window
Alert
Enter PIN code + 08 + 1 +
Turn on
Enter PIN code + 08 + 2 +
Turn Off
ARM Mode
Enter PIN code +
Exit Delay: Arm LED flashes and a beeping
sound is heard (will beep faster at the last 5
seconds countdown)
ARM Mode: Arm Key LED is on
Home Mode
Enter PIN code +
Exit Delay: Arm LED flashes and a beeping
sound is heard (will beep faster at the last 5
seconds countdown)
Home Mode: Home mode Key LED is on
DISARM
Mode
Enter PIN code +
Disarm Mode: Disarm Key LED turns on
Note: The following operations are available only in DISARM Mode
Record
1. Start recording alarm message (about 10