EMKO Elektronik warrants that the equipment delivered is free from defects in material and workmanship. This
warranty is provided for a period of two years. The warranty period starts from the delivery date. This warranty is in
force if duty and responsibilities which are determined in warranty document and instruction manual performs by
the customer completely.
Repairs should only be performed by trained and specialized personnel. Cut power to the device before
accessing internal parts.
Do not clean the case with hydrocarbon-based solvents (Petrol, Trichlorethylene etc.). Use of these solvents can
reduce the mechanical reliability of the device. Use a cloth dampened in ethyl alcohol or water to clean the
external plastic case.
1.2 WARRANTY
1.3 MAINTENANCE
Carefully unpack the unit and check for damage to the unit or to the cables supplied. Retain the packing
in case of future need, e.g. returning the unit for adjustment.
Check the contents, as follows:
• One EPC unit.
• Operating Manual.
• Screw fixings.
• RS-232 Cable.
Before commencing installation:
• Disconnect all electrical power to the machine.
• Make sure the machine cannot operate during installation.
• Follow all of the machine manufacturer’s safety warnings.
• Read and follow all installation instructions.
Report any shortage or damage to your local sales office as soon as possible.
A visual inspection of this product for possible damage occured during shipment is recommended
before installation. It is your responsibility to ensure that qualified mechanical and electrical technicians
install this product.
Be sure to use the rated power supply voltage to protect the unit against damage and to prevent failure.
Keep the power off until all of the wiring is completed so that electric shock and trouble with the unit can
be prevented.
Never attempt to disassemble, modify or repair this unit. Tampering with the unit may results in
malfunction, electric shock or fire.
Do not use the unit in combustible or explosive gaseous atmospheres.
During the equipment is putted in hole on the metal panel while mechanical installation some metal burrs
can cause injury on hands, you must be careful.
Montage of the product on a system must be done with it’s own fixing screws. Do not do the montage of
the device with inappropriate fixing screws. Be sure that device will not fall while doing the montage.
It is your responsibility if this equipment is used in a manner not specified in this instruction manual.
Before beginning installation of this product, please read the instruction manual and warnings
below carefully.
c
2. INSTALLATION
8
To Next Page
Loading...
Need help?
General
