Endress+Hauser Cerabar M - Page 118

Commissioning with an operating menu (onsite display/FieldCare) Cerabar M, Deltabar M, Deltapilot M
118 Endress+Hauser
Expert → System → Management
Format 1st value (004)
Options
Specify the number of places after the decimal point for the value displayed in the
main line.
Options:
•Auto
•x
•x.x
•x.xx
•x.xxx
•x.xxxx
• x.xxxxx
Factory setting:
Auto
FF input source (233)
Options
Select which input of the Input Selector Block will appear as an external value on
the display (see "Display mode (001)" parameter).
Options:
•Input1
•Input2
•Input3
•Input4
This list corresponds to the inputs of the Input Selector Block. The Block is always
instantiated but does not have to be in the Auto mode.
Factory setting:
Input1
FF input unit (234)
Options
Select the unit of the external value.
If a new pressure unit is selected, all pressure-specific parameters are converted
and displayed with the new unit.
Options:
• mbar, bar
• mmH2O, mH2O,
•inH2O, ftH2O
• Pa, kPa, MPa
•psi
•mmHg, inHg
•kgf/cm
2
Factory setting:
mbar or bar depending on the sensor nominal measuring range, or as per order
specifications
FF input form (235)
Options
Select the formatting of the external value.
Factory setting:
x.x
Parameter name Description
Enter reset code (124)
Entry
Reset parameters completely or partially to the factory values or order
configuration,
 ä 55, "Resetting to factory settings (reset)".
Factory setting:
0
Parameter name Description