Endress+Hauser Cerabar M - Overview of the Onsite Display Operating Menu

Commissioning with an operating menu (onsite display/FieldCare) Cerabar M, Deltabar M, Deltapilot M
108 Endress+Hauser
8.10 Overview of the onsite display operating menu
All parameters and their direct access code (in brackets) are listed in the following table. The
page number refers to where a description of the parameter can be found.
Level 1 Level 2 Level 3 Level 4 Page
Parameters in italics are read-only parameters and cannot be edited. Specific settings, such as the measuring mode, dry or wet calibration, or hardware
locking, determine whether these parameters are displayed.
Language (000)  ä 117
Display/operat. Display mode (001)  ä 117
Add. disp. value (002)  ä 117
Format 1st value (004)  ä 118
FF input source (233)  ä 118
FF input unit (234)  ä 118
FF input form (235)  ä 118
Setup Lin./SQRT switch (133) (Deltabar)  ä 119
Measuring mode (005)
Measuring mode (182)
 ä 119
Switch P1/P2 (163)  ä 121
High-pressure side (006) (Deltabar)
High-pressure side (183) (Deltabar)
 ä 121
Press. eng. unit (125)  ä 120
Corrected press. (172)  ä 122
Pos. zero adjust (007) (Deltabar M and gauge pressure sensor)
Calib. offset (192) / (008) (absolute pressure sensor) (absolute pressure sensors)
 ä 120
 ä 120
Max. flow (009) ("Flow" measuring mode) (Deltabar)  ä 128
Max. pressure flow (010) ("Flow" measuring mode) (Deltabar)  ä 128
Empty calib. (028) ("Level" measuring mode and "Calibration mode (027)" = wet)  ä 124
Full calib. (031) ("Level" measuring mode and "Calibration mode (027)" = wet)  ä 124
Damping switch (164) (read only)  ä 120
Damping value (017)
Damping value (184)
 ä 120
Flow (018) ("Flow" measuring mode) (Deltabar)  ä 128
Level before lin. (019) ("Level" measuring mode)  ä 125
Pressure af. damp (111)  ä 122
Extended setup Code definition (023)  ä 116
Pd-tag. (022)  ä 117
Operator code (021)  ä 116
Level (Level measuring mode) Level selection (024)  ä 123
Unit before lin. (025)  ä 123
Height unit (026)  ä 123
Calibration mode (027)  ä 123
Empty calib. (028)  ä 124
Empty pressure (029)
Empty pressure (185)
 ä 124
Empty height (030)
Empty height (186)
 ä 124
... ... ... Full calib. (031)  ä 124