Endress+Hauser Cerabar M - Page 207

Cerabar M, Deltabar M, Deltapilot M Commissioning with the FF configuration program
Endress+Hauser 207
Reset logbook/
RESET_ALARM_HISTORY
Index: 22
Data type: unsigned8
Access: wr for Auto, OOS
Parameter for deleting the logbook entries.
Options:
•Abort
• Reset
Factory setting:
Abort
Actual errors/
DIAG_ALARM_TABLE
Display
Index: 23
Data type: OctetString8
Access: read only
Bit field summary of active alarms/warnings.
Operating hours/
OPERATING_HOURS_VALUE
Display
Index: 24
Data type: unsigned32
Access: read only
Displays the hours of operation.
Diagnostic code/
ACTUAL_HIGHEST_ALARM
Display
Index: 25
Data type: record
Access: read only
Table displaying the 10 current active alarms/warnings.
Instructions/
ACTUAL_MAINTENANCE_IN
STRUCT_INFO
Display
Index: 26
Data type: record
Access: read only
Table displaying the instructions for the current active alarms/warnings.
Last diag. code/
LAST_ALARM_INFOS
Display
Index: 27
Data type: record
Access: wr for Auto, OOS
Table displaying the last 10 current rectified alarms/warnings.
Reset/RESET_INPUT_VALUE
Entry
Index: 28
Data type: unsigned16
Access: wr for Auto, OOS
Reset parameters completely or partially to the factory values or order
configuration,
 ä 55, "Resetting to factory settings (reset)".
Factory setting:
0
Config. Recorder/
CONFIGURATION_ COUNTER
Display
Index: 29
Data type: unsigned16
Access: read only
Displays the configuration counter.
This counter is increased by 1 every time a configuration parameter or group is
changed.
The counter counts up to 65535 and then starts again at 0.
Diagnostic Transducer Block
Parameter Description