Endress+Hauser Deltabar S PMD75 - Page 169

Cerabar S/Deltabar S/Deltapilot S FOUNDATION Fieldbus Parameter description (Local operation and FieldCare)
Endress+Hauser 169
P01-xMx7xxxx-19-xx-xx-en-009
Fig. 48: BASIC SETUP function group for the "Level" measuring mode and "Height linearized" level mode, continue
calibration with LINEARIZATION function group → ä 186 ff.
*
*
*
*
*
*
*
*
*
*
*
*
*
*
Linear
Pressure Linearized
Height Linearized
Parameters marked with an asterisk "*"
are not always displayed.Thedisplay
depends on the settings of other parameters,
see the following Table.
Flow
Pressure
Level
PRESS. ENG. UNIT
CUSTOMER UNIT P
CUST. UNIT FACT. P
LEVEL MODE
MEASURING MODE
MEASURED VALUE
QUICK SETUP
BASICSETUP
DISPLAYSETTINGS
POSITION ADJUSTMENT
OPERATING MENU
EXTENDED SETUP
VOLUME UNIT
CUSTOMER UNIT M
CUST. UNIT FACT. V
LEVEL MIN
LEVEL MAX
...+Volume
...+Mass
...+%
Height+...
%-Height+...
dry
wet
MASS UNIT
CUSTOMER UNIT V
CUST. UNIT FACT. M
DAMPING VALUE
EMPTY CALIB. DENSITYUNIT
ADJUST DENSITY
HEIGHT UNIT
100% POINT
ZERO POSITION
CUSTOMER UNIT H
CUST. UNIT FACT. H
FULL PRESSURE
EMPTY PRESSURE
FULL CALIB.
ADJUSTED DENSITY
CALIBRATION MODE
HEIGHT UNIT
CUSTOMER UNIT H
CUST. UNIT FACT. H
COMB. MEASURAND
DENSITYUNIT