Installation Gammapilot M FMG60 PROFIBUS PA
10 Endress+Hauser
Hazardous area
To eliminate a danger for persons or for the facility when the device is used in the hazardous
area (e.g. explosion protection, pressure vessel safety):
‣
Based on the nameplate, check whether the ordered device is permitted for the intended
use in the hazardous area.
‣
Observe the specifications in the separate supplementary documentation that is an integral
part of these Instructions.
2.8 Product safety
This measuring device is designed in accordance with good engineering practice to meet state-
of-the-art safety requirements, has been tested, and left the factory in a condition in which it
is safe to operate.
It meets general safety standards and legal requirements. It also complies with the EC
directives listed in the device-specific EC Declaration of Conformity. Endress+Hauser confirms
this by affixing the CE mark to the device.
3 Installation
3.1 Incoming acceptance, product identification, transport, storage
3.1.1 Incoming acceptance
Check the packaging and contents for any signs of damage. Check the shipment, make sure
nothing is missing and that the scope of supply matches your order.
3.1.2 Product identification
The measuring device can be identified in the following ways:
• Using the nameplate specifications.
• Using the order code with a breakdown of the device features on the delivery note.
• By entering the serial number of the nameplates into W@M Device Viewer.
(www.endress.com/deviceviewer): All the information about the measuring device is
displayed.
For an overview of the scope of the Technical Documentation provided:
Enter the serial number of the nameplates into W@M Device Viewer. (www.endress.com/
deviceviewer)
3.1.3 Transport
L
CAUTION
Risk of injury
‣
Follow the safety instructions and transport conditions for devices weighing more than
18 kg (39.69 lb).
To Next Page
Loading...
