Endress+Hauser Gammapilot M FMG60 - Wiring in terminal compartment A

Operation Gammapilot M FMG60 PROFIBUS PA
26 Endress+Hauser
4.11 Post-connection check
After wiring the device, carry out the following checks:
• Is the protective ground connected?
• Is the potential matching line connected?
• Is the terminal assignment correct?
• Are the cable glands and dummy plugs tight?
• Are the fieldbus connectors and the FHX40 connector fixed securely?
• Are the covers screwed tightly onto the connection compartments?
• For Dust-Ex devices: is the protective sleeve for the FHX40 socket mounted correctly?
• Is the cover of connection compartment 1 secured by the cover clamp?
L
WARNING
‣
The Gammapilot M may only be operated if the cover of connection compartment 1 is
closed.
5 Operation
5.1 Display operation
5.1.1 Display and operating elements
The LCD module VU331 for displaying and operating is located inside the remote display and
operating unit FHX40. The measured value can be read through the FHX40 window. The
FHX40 must be opened in order to operate the device. Remove the four screws on the cover to
do so.
1
2
3
A0018096
1 Gammapilot M
2 FHX40
3 Operating module VU331