Endress+Hauser Gammapilot M FMG60 - Fieldbus connectors

Wiring Gammapilot M FMG60 PROFIBUS PA
24 Endress+Hauser
+
-
PT100
IN CASCADE OUT
SIM WP
OFF
ON
3
4
5
6
7
8
9
10
11
12
+ - - +
0
13
2
A0019827
1. Unscrew the cover
2. Push the following cables through the corresponding cable glands or cable entries:
signal cable (if the signal output is located in connection compartment 2), Pt100 cable
(if present), cascading cable (input and/or output, if required)
3. Wire up according to the terminal assignment diagram
4. Tighten the cable glands or cable entries so that they are leak-tight
5. Screw the cover securely back onto the connection compartment
4.9 Connecting the remote display and operating unit FHX40
The remote display and operating unit FHX40 is available as an accessory. It is connected to
the FHX40 connector of the Gammapilot M via the cable supplied. The housing of the
Gammapilot M does not have to be opened for this.