Endress+Hauser Micropilot FMR20 - Page 78

Operating menu Micropilot FMR20 HART
78 Endress+Hauser
User interface • Strong
• Medium
• Weak
• No signal
Confirm distance 
Navigation  Setup → Confirm distance
Description Does the measured distance match the real distance?
Select one of the options:
- Manual map
To be selected if the range of mapping is to be defined manually in the 'Mapping end point'
parameter. A comparison between actual and indicated distance is not required in this
case.
- Distance ok
To be selected if the measured distance matches the actual distance. The device performs a
mapping.
- Distance unknown
To be selected if the actual distance is unknown. A mapping can not be performed in this
case.
- Factory map
To be selected if the present mapping curve (if one exists) is to be deleted. The device
returns to the 'Confirm distance' parameter and a new mapping can be recorded.
Selection • Manual map
• Distance ok
• Distance unknown
• Factory map
Mapping end point 
Navigation  Setup → Map. end point
Description This parameter defines up to which distance the new mapping is to be recorded.
The distance is measured from the reference point, i.e. from the lower edge of the
mounting flange or sensor.
User entry 0 to 21.8 m
Present mapping
Navigation  Setup → Present mapping
Description Indicates up to which distance a mapping has already been recorded.