Endress+Hauser Micropilot FMR20 - Process Variable Value; Simulation; Simulation Submenu; Value Current Output

Operating menu Micropilot FMR20 HART
98 Endress+Hauser
15.4.2 "Simulation" submenu
Navigation  Diagnostics → Simulation
Simulation 
Navigation  Diagnostics → Simulation → Simulation
Description Select process variable to be simulated.
The Simulation is used to simulate specific measuring values or other conditions. This
helps to check the correct configuration of the device and connected control units.
Selection • Off
• Current output
• Distance
Value current output 
Navigation  Diagnostics → Simulation → Value curr.out 1
Description Defines the value of the simulated output current.
User entry 3.59 to 22.5 mA
Process variable value 
Navigation  Diagnostics → Simulation → Proc. var. value
Description Value of the simulated process variable.
Downstream measured value processing and the signal output use this simulation value. In
this way, users can verify whether the measuring device has been configured correctly.
User entry 0 to 21.8 m