Endress+Hauser Micropilot FMR56 - Page 61

Micropilot FMR50/FMR51/FMR52/FMR53/FMR54/FMR56/FMR57 FOUNDATION Fieldbus The "Expert" menu
Endress+Hauser 61
Prerequisites Only visible if one of the following linearization types has been selected:
• Pyramid bottom
• Conical bottom
• Angled bottom
Description Definition of the intermediate height H
0%
H
A0013264
Input range 0 to 200 m (0 to 656 ft)
Factory setting 0 m (0 ft)
Additional information The value must be specified in the selected distance unit (→  38).
Table mode (2303)
Navigation Expert → Sensor → Linearization → Table mode
Write access Maintenance
Prerequisite Only visible if the "Table" linearization type has been selected.
Description Defines the method used to enter linearization points into the table.
Options • Manual
The level and the associated linearized value are entered manually for each linearization
point.
• Semi-automatic
The level is measured by the device for each linearization point. The associated
linearized value is entered manually.
• Clear table
Deletes the existing linearization table.
• Sort table
Rearranges the linerization points into an ascending order.
Factory setting Manual