Endress+Hauser Proline Promag 55 - Page 103

Device functions Proline Promag 55 FOUNDATION Fieldbus 3 Transducer Block
Endress+Hauser 103
Add. Line Mux -
Display Mode
AUTO - OOS
! Note!
The option is not active unless one of the following was selected in the
parameter "Add. Line Mux - Assign" ( → Page 101):
• MASS FLOW BARGRAPH IN %
• VOLUME FLOW BARGRAPH IN %
Use this parameter to define the format of the bar graph.
Options:
STANDARD (Simple bar graph with 25 / 50 / 75% gradations and
integrated sign).
A0001258
SYMMETRY (Symmetrical bar graph for positive and negative directions of
flow, with –50 / 0 / +50% gradations and integrated sign).
A0001259
Factory setting:
STANDARD
1 = Main line
2 = Additional line
3 = Information line
A0001253
Info Line -
Assign
AUTO - OOS Use this parameter to define the display value assigned to the information
line (the bottom line of the local display) during normal measuring
operation.
Options:
OFF
VOLUME FLOW IN %
MASS FLOW IN %
VOLUME FLOW BARGRAPH IN %
MASS FLOW BARGRAPH IN %
FLOW VELOCITY
OPERATING/SYSTEM CONDITIONS
DISPLAY FLOW DIRECTION
TOTALIZER (1 to 3)
AI1 - OUT VALUE
AI2 - OUT VALUE
AI3 - OUT VALUE
AI4 - OUT VALUE
AI5 - OUT VALUE
PID - IN VALUE (controlled variable)
PID - CAS IN VALUE (external set point)
PID - OUT VALUE (manipulated variable)
DEVICE PD-TAG (tag name)
Factory setting:
OPERATING/SYSTEM CONDITIONS
"Display" Transducer Block/base index 1800:
Parameter
Write access with
operating mode
(MODE_BLK)
Description
Esc
E
+
-
1
2
3