Endress+Hauser Proline Promag 55 - Installation

Device Functions Proline Promag 55 FOUNDATION Fieldbus 3 Block MEASURED VARIABLES
Endress+Hauser 11
3.2 Group SYSTEM UNITS
3.2.1 Function group CONFIGURATION
MEASURED
VARIABLES
A ⇒ MEASURING VALUES AAA
⇓
SYSTEM UNITS ACA ⇒ CONFIGURATION 040
Function description
MEASURED VARIABLES → SYSTEM UNITS → CONFIGURATION
You can select the units for measured variables in this function group.
! Note!
The units selected here have no effect on the fieldbus. They are only used for the local display and for assigned
instrument functions.
UNIT MASS FLOW
(0400)
Use this function to select the unit for displaying the calculated mass flow (mass/time).
The mass flow is derived from the preset (compensated) specific fluid density and the
measured volume flow.
The unit you select here is also valid for:
• Low flow cut off
Options:
Metric:
Gram → g/s; g/min; g/h; g/day
Kilogram → kg/s; kg/min; kg/h; kg/day
Metric ton → t/s; t/min; t/h; t/day
US:
Ounce → oz/s; oz/min; oz/h; oz/day
Pound → lb/s; lb/min; lb/h; lb/day
Ton → ton/s; ton/min; ton/h; ton/day
Factory setting:
Nominal diameter and country dependent → Page 123 ff.
UNIT MASS
(0401)
Use this function to select the unit for displaying the calculated mass. The mass is derived
from the preset (compensated) specific fluid density and the measured volume.
Options:
Metric → g; kg; t
US → oz; lb; ton
Factory setting:
Nominal diameter and country dependent → Page 123 ff.
! Note!
The unit for the totalizers is independent of your choice here.
The unit for each totalizer is selected separately for the totalizer in question.